Using the Tracker Remote with Fault Finder
To get the maximum performance from an energizer you need to be able to measure and monitor your electric fence system effectively.
How to Use
Start near the energizer's lead-out wires with your PEL Tracker Remote with Fault Finder or your PEL Tracker PV100 Fault Finder.
Move down the fence line following the arrow away from the energizer. Take readings at regular intervals and at any junction point.
The previous reading is shown briefly in the top right corner of the screen so that you can compare readings. If the current reading suddenly falls, you have gone past a fault. Retrace your steps to find the fault. Note that after a few seconds the previous current reading will be replaced with the present voltage reading (kV).